3D print 555TEN

187 m of 555TEN, 51 mm on your shelf

Make this print opens the generator on a 600 m square around the landmark. Buildings print at close to true scale, so the landmark grows with the print size.

1. Tall, narrow shaft

   The model is tall and narrow, so each layer near the top covers a small area. Print slowly with good cooling, and use 0.12 to 0.16 mm layers to keep the walls clean.

2. Small facade details

   Facade edges and small surface details soften first on a small print. Print friendly adapts them at smaller sizes; Full detail keeps them for a large print or a fine nozzle.

3. One piece with the ground

   555TEN is joined to the ground in the exported file, and the four-side check found no floating parts, so nothing needs gluing.

4. Pick the detail for your nozzle

   In the Buildings settings, set Landmark detail to Print friendly to adapt thin parts and small details to the print scale. Full detail keeps every modeled feature, for larger prints or a finer nozzle.

5. Colors

   Buildings, roads, water and ground arrive as separate filament slots in the 3MF. 555TEN takes the building color.

6. File format

   You get a 3MF for Bambu Studio, OrcaSlicer or PrusaSlicer. Any of them can save it as STL if you need one.